Problem s generovanim fontu (emTeX)

[Petr Sojka]

"Petr Prikryl wrote:"
: Zdravim uzivatele TeXu,
Napodobne,
:
: Setkal jsem se s problemem zobrazeni stazeneho dokumentu v dvi podobe.
: Obsahuje fonty, ktere se musi vygenerovat a ono to pri tom generovani
: skonci nejak divne.

Aktualni verze zdroju
(ftp://ftp.cstug.cz/pub/tex/CTAN/macros/lamstex/mf/lams4.mf)
zacina poznamkou:

% LAMS4.MF      VERSION 1.0
% COPYRIGHT (C) 1989 BY THE TEXPLORATORS CORPORATION
% ALL RIGHTS RESERVED

if unknown cmbase: input cmbase fi
% replace the macro adjust_fit by version used in earlier cmbase files to
% avoid division by zero error caused by newer versions of cmbase
% Patch by Ingo Hadan (Jan 97)

Melo by tedy stacit aplikovat tento zdroj.
Zdravim

Petr.Sojka at cstug.cz

: ---------------------------------------------------------------------
: This is METAFONT (mf386), Version 2.718 [4b] (preloaded base=plain 97.6.11)  19
: SEP 1997 10:35
: **&plain \mode=laserjet; mag=1.2; input lams4
: (q:/emtex/mfinput/lamstex/lams4.mf (q:/emtex/mfinput/cm/cmbase.mf) [0] [13]
: [26] [39] [52] [65] [78] [91] [104] [1] [14] [27] [40] [53] [66] [79] [92]
...
: [89] [102] [115] [12] [25] [38] [51] [64] [77] [90] [103] [116]
: >> -1
: ! Division by zero.
: <to be read again>
:                    )
: adjust_fit->...pansion(w/(charwd_in*hppp))
:                                           ;
: l.496 adjust_fit(0,0)
:                      ; pickup crisp.nib;
: You're trying to divide the quantity shown above the error
: message by zero. I'm going to divide it by one instead.
:
: [117]
: >> -1
: ! Division by zero.